Skip to main content
An Official West Virginia Government Website
New River Gorge Bridge

APL: 707.002.001 1/12/2016

  • Category: 661.2 -- Type B1 Delineators (Std. Detail Sheet)
  • Material Code: 661.002.004
  • Effective Date: January 12, 2016
  • Contact: Donald Simmons
Guardrail Post "Saddle" Type Delineators (See note 1)
ManufacturerProductApproval Number
Duraflex CorporationRingwood, NJDCC1.01.661Flexx 20201390155A(see notes 1,2,3 and 4)
Artuk Inc.Elgin, ILformerlyAstro Optics Corp.AOC1.01.661FR1438519A(see notes 1,2,3 and 4)
Pexco DavidsonTraffic Control ProductsformerlyFiltronia Extrusion, IncPDT1.01.661I-FLEX-161390157A(see notes 1,2,3 and 4)
Concrete Barrier or Guardrail Blockout "T-Barrier"
ManufacturerProductApproval Number
Duraflex CorporationRingwood, NJDCC1.01.661Railrider1390158A(see notes 1,2,3 and 4)
Artuk Inc.Elgin, ILformerlyAstro Optics Corp.AOC1.01.661FT1438520A(see notes 1,2,3 and 4)
Pexco DavidsonTraffic Control ProductsformerlyFiltronia Extrusion, IncPDT1.01.661T-161390160A(see notes 1,2,3 and 4)
Plastic Safety SystemsPSS1.01.661Quik-Mark1390161A(see notes 1,3,5 and 6)
Pexco DavidsonTraffic Control ProductsformerlyFiltronia Extrusion, IncPDT1.01.661Big Dog PCBM1390162A(see notes 1,3,5 and 6)
Concrete Barrier Side Mount Type Delineators
ManufacturerProductApproval Number
3M3MC1.01.709LDS-W346(white) and LDS-FY346 (fl.1390163A(see notes1 and 7)

Notes and Remarks:

  1. 1. All B-1 delineators shall be installed in accordance with the recommendations of the manufacturer. The sheeting on all B-1 delineators shall be pre-installed on the face(s) of the delineators by the manufacturer.
  2. 2. 4"x4" reflective face(s).
  3. 3. To be used only in the following color combinations ( as specified in the contract plans):
    • white sheeting on the front only or front and back.
    • white sheeting on the front and red sheeting on the back.
    • fluorescent-yellow (if Type ASTM-IX) or yellow (if Type ASTM-III) sheeting on the front only or front and back.
    • fluorescent-yellow (if Type ASTM-IX) or yellow (if Type ASTM-III) sheeting on the front and resheeting on the back.
  4. 4. Sheeting used shall be Type ASTM-IX
  5. 5. 12" x 8" reflective face(s).
  6. 6. Sheeting shall be Type ASTM-III, reboundable or non-reboundable, per the manufacturer's recommendation.
  7. 7. The delineator shall be installed such that the top edge of the delineator is approximately 6" below the top of the barrier. The color of the delineator shall be white or fluorescent-yellow, as required, in order to match the color of the edge line that the delineator is intended to supplement.